Online: 14 Member & 57 GuestLogin | Register

Who Download This

May Interest You

Download 449
times

6
Pages

2007 Harley-Davidson Dyna Family: Specifications
On: 59 minutes ago
Topic: Motorcycle Manual

Download 433
times

139
Pages

Harley-Davidson Users Manual
On: 59 minutes ago
Topic: Motorcycle Manual

Download 302
times

22
Pages

KAWASAKI ZX-12 2000-2001 KAWASAKI ZX-7R 1996-1999
On: 2 hours ago
Topic: Motorcycle Manual

Download 38
times

1
Page

SC150 SCOOTER OWNERS MANUAL
On: 4 hours ago
Topic: Motorcycle Manual

Download 49
times

44
Pages

4360 - BSA Service Manual
On: 6 hours ago
Topic: Motorcycle Manual

Home // Manuals // Motorcycle Manual

PDF: T-REX 43CC GAS POWERED SCOOTER USER MANUAL

Download 3 times Source: www.neoscooters.com // Topic: Motorcycle Manual File Size: 289.99 kb // Total of Page: 12 Page(s) Last download by juanjose1 Last download on: 2 weeks ago Share this info: Sample of page (click to enlarge) Short Desciption: Please read the manual and all safety notice carefully, understand its functions,. maintenance and operating procedures completely before using the scooter. ... Content Inside: Make sure that all cables are not binding and have good action. Check gas lines so they are not too close to any moving parts. Make sure handlebar hinge is secure. 1. Fill fuel tank with premixed two-stroke (cycle) oil in it. We recommend a ratio of 32 to 1. DO NOT use straight gas; engine will seize and can cause injury. 2. Prime the carburetor by pressing the bulb located on the bottom of the carburetor until all air bubbles and fuel flow back to the tank through the clear line. 3. Place the choke (the lever located on the side of the air filter) in the "OFF" (up ) position (this does not mean the choke is off, it means the engine is off - the choke is on in this position) 4. Pull the pull start to get the engine going. If this is your first or second time starting the scooter, it may take 10-20 pulls to start it. This will get much easier after the scooter is broken in. Do not yank on pull starter too hard. Short quick pulls will work fine; yanking too hard will break pull starter. 5. Once the scooter is started, let the engine idle for a minute, and then Flip the choke to the "ON" (lever down)position before the engine dies. 6. Give the engine a little throttle right after it starts to get it going. You may also have to give it a little bit of throttle while pulling the pull start, although this often not necessary. Press the kill button to stop the engine